User Tools

Site Tools


slice:dcc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
slice:dcc [2020/04/30 16:50]
Michael Radunsky [Laser and Photodiode Connections]
slice:dcc [2020/04/30 16:54]
Michael Radunsky [Laser and Photodiode Connections]
Line 210: Line 210:
  
 === Connection to Monitor Photodiode === === Connection to Monitor Photodiode ===
-Either of the two configurations of the monitor photodiode seen in <imgref mon_pd> will work for the signal proportional to the laser diode power for operating in Constant Power mode.  Depending on how you have completed the monitor photodiode circuit, you may have to adjust the [[slice:dcc#setting_the_operating_power_in_constant_power_mode|sign of the Constant Power feedback loop]].+Either of the two configurations of the monitor photodiode seen in <imgref mon_pd> will work for the signal proportional to the laser diode power for operating in Constant Power mode.  Depending on how you have completed the monitor photodiode circuit, you may have to adjust the [[slice:dcc#constant_power_mode|sign of the Constant Power feedback loop]].
  
  
-<imgcaption mon_pd|Wiring configuration for monitor photodiode>{{ :slice:dcc:anode_cathode_ground_monitor_pd.png |}}</imgcaption>+<imgcaption mon_pd|Wiring configurations for monitor photodiode>{{ :slice:dcc:anode_cathode_ground_monitor_pd.png |}}</imgcaption>
 ==== Setting the Operation Mode ==== ==== Setting the Operation Mode ====
 The SLICE-DCC has two operation modes: Constant Current and Constant Power.  The operation mode, as with most other operating parameters can be set independently for each channel.  To toggle between Constant Current and Constant Power modes, from the Home screen, touch the window labelled either CH X Constant Current or CH X Constant Power.  If the channel is in Constant Current Mode, you will be presented with the window seen in <imgref cc_param>. \\ The SLICE-DCC has two operation modes: Constant Current and Constant Power.  The operation mode, as with most other operating parameters can be set independently for each channel.  To toggle between Constant Current and Constant Power modes, from the Home screen, touch the window labelled either CH X Constant Current or CH X Constant Power.  If the channel is in Constant Current Mode, you will be presented with the window seen in <imgref cc_param>. \\
slice/dcc.txt · Last modified: 2020/04/30 16:54 by Michael Radunsky