Product Manuals

User Tools

Site Tools

You are here: manuals » slice » dcc
slice:dcc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
slice:dcc [2020/04/29 22:51] – [Connecting to the Laser Diode] Michael Radunskyslice:dcc [2020/04/29 22:51] – [Setting the Operation Mode] Michael Radunsky
Line 218: Line 218:
 Touching the Window labeled Control Mode will allow you to toggle the channel back & forth between Constant Current and Constant Power modes as seen in <imgref cc_cp>. Touching the Window labeled Control Mode will allow you to toggle the channel back & forth between Constant Current and Constant Power modes as seen in <imgref cc_cp>.
  
-<imgcaption cc_cp>|Constant Current or Constant Power>{{ :slice:dcc:cc_cp_toggle.png?430x254 |}}</imgcaption> \\+<imgcaption cc_cp|Constant Current or Constant Power>{{ :slice:dcc:cc_cp_toggle.png?430x254 |}}</imgcaption> \\
 ==== Setting the Current Limit ==== ==== Setting the Current Limit ====
 The user can set a maximum deliverable current so as not to exceed the rated maximum for their device.  From the Home screen, touch the window labelled either CH X Constant Current or CH X Constant Power. Depending on the operation mode, you will be presented with either <imgref cc_param> or <imgref cp_param>.  The user can set a maximum deliverable current so as not to exceed the rated maximum for their device.  From the Home screen, touch the window labelled either CH X Constant Current or CH X Constant Power. Depending on the operation mode, you will be presented with either <imgref cc_param> or <imgref cp_param>. 
slice/dcc.txt · Last modified: 2024/03/27 21:07 by Thomas Bersano