Differences

This shows you the differences between two versions of the page.

--- slice [2020/03/25 21:07] – Michael Radunsky
+++ slice [2023/06/09 22:41] (current) – external edit 127.0.0.1
@@ Line 7: / Line 7: @@
   * [[slice:qt:firmware|sl firmware upgrade instructions]]
   * [[slice:qt:api|SLICE-QTC API]]
+  * [[slice:Z-N|Ziegler-Nichols loop tuning instructions]]
+=== SLICE-(D)LC (Dual-channel) Laser Controller with ultra-low-noise and two channels of temperature control ===
+  * [[slice:lc|SLICE-LC and SLICE-DLC Manual]]
+  * [[slice:lc:firmware|SLICE firmware upgrade instructions]]
+  * [[slice:dlc:api|SLICE-(D)LC API]]
+=== SLICE-OPL Offset Phase Lock Servo ===
+  * [[slice:opl|SLICE-OPL Manual]]
+  * [[slice:lc:firmware|SLICE firmware upgrade instructions]]
+  * [[slice:opl:api|SLICE-OPL API]]
 === SLICE-DCC Dual-Channel Current Controller ===
@@ Line 17: / Line 30: @@
 === SLICE-DHV Dual-Channel High-Voltage Amplifier ===
-  * [[slice:dhv|SLICE-DHVManual]]
+  * [[slice:dhv|SLICE-DHV Manual]]
   * [[slice:quick_start_DHV|SLICE-DHV Quick Start]]
   * [[slice:qt:firmware|SLICE firmware upgrade instructions]]
@@ Line 25: / Line 38: @@
   * [[slice:qt:firmware|SLICE firmware upgrade instructions]]
+===== Mode-Locked Lasers and Frequency Combs =====
+==== FFC Fiber Frequency Combs ====
+  /** [[ffC:100M|FFC-100 Frequency Comb Manual]]*/
+  * [[ffC:100|FFC-100 Frequency Comb Quick Start Guide]]
+  * [[ffc:comb_module_quickstart|FFC-CM Frequency Comb Module Quickstart Guide]]
+  * [[ffc:100Old|FFC-100 Frequency Comb Quick Start Guide (Firmware 1.195 and Older)]]
+==== Locking Electronics ====
+  * [[ffc:Locking_Electronics:SLICE-FPGA|SLICE-FPGA]]
+  * [[ffc:Locking_Electronics:SLICE-FPGA-II|SLICE-FPGA-II]]