ice:servo-sc1
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
ice:servo-sc1 [2016/01/23 00:07] – created Ben Luey | ice:servo-sc1 [2021/08/26 15:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 28: | Line 28: | ||
<WRAP center round box 75%> | <WRAP center round box 75%> | ||
^ ^ ICE-SC1 | ^ ^ ICE-SC1 | ||
- | ^ Peak Lock Servo ^ ^^ ^ | + | ^ Side Lock Servo ^ ^^ ^ |
- | |< | + | |Bandwidth((Calculated based on RF dither frequency of 4 MHz which limits servo bandwidth))| |
- | |< | + | |Input Impedance | 50 | Ω | |
- | |< | + | |Input Range | ±10 | V | |
- | |< | + | |Dither Frequency((Not implemented as of November, 2017)) |
- | |< | + | |Phase Shift Resolution((Not implemented as of November, 2017)) |
+ | |Input Voltage Noise(( Referenced to 50Ω load)) | TBD | nV/ | ||
+ | ^ Ramp Parameters ^ ^^ ^ | ||
+ | |Max. Ramp Amplitude | ±10 | V | ||
^ Loop Filter Parameters ^ ^^ ^ | ^ Loop Filter Parameters ^ ^^ ^ | ||
- | |< | + | |DC Offset Range | ±10 | V | |
- | |< | + | |Proportional Gain (ref to DC Error) | -38 to +30 | dB | |
- | |< | + | |Proportional Gain Resolution | 2 | dB | |
- | |< | + | |First Integrator| |
- | |< | + | |Second Integrator| |
- | |< | + | |Differential| |
+ | |Differential Gain | 18 | dB | | ||
+ | |Output Range | ±10 | V | | ||
+ | ^ Output Control ^ ^^ ^ | ||
+ | |Adjustable Output Limits | ±10 | V | | ||
^Electrical Specifications^^^^^ | ^Electrical Specifications^^^^^ | ||
Line 46: | Line 53: | ||
|5V_A Current Draw | | N/A | | A | | |5V_A Current Draw | | N/A | | A | | ||
|5V_D Current Draw | | 70 | | mA | | |5V_D Current Draw | | 70 | | mA | | ||
- | |+15V Current Draw((Current draw depends on output load, assuming high impedance. Current may be initially high on power-on)) | | 160 | 200 | mA | | + | |+15V Current Draw((Current draw depends on output load, assuming high impedance. Current may be initially high on power-on)) (Sidelock) | | 160 | 200 | mA | |
- | |-15V Current Draw((Current draw depends on output load, assuming high impedance. Current may be initially high on power-on)) | | 120 | 150 | mA | | + | |-15V Current Draw((Current draw depends on output load, assuming high impedance. Current may be initially high on power-on)) (Sidelock) | | 120 | 150 | mA | |
ice/servo-sc1.1453507665.txt.gz · Last modified: 2021/08/26 14:26 (external edit)