ice:servo-sc1
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
ice:servo-sc1 [2018/04/19 00:25] – [Specifications] Michael Radunsky | ice:servo-sc1 [2018/12/20 00:56] – Michael Radunsky | ||
---|---|---|---|
Line 29: | Line 29: | ||
^ ^ ICE-SC1 | ^ ^ ICE-SC1 | ||
^ Side Lock Servo ^ ^^ ^ | ^ Side Lock Servo ^ ^^ ^ | ||
- | |< | + | |Bandwidth((Calculated based on RF dither frequency of 4 MHz which limits servo bandwidth))| |
- | |< | + | |Input Impedance | 50 | Ω | |
- | |< | + | |Input Range | ±10 | V | |
- | |< | + | |Dither Frequency((Not implemented as of November, 2017)) | 4 | MHz | |
- | |< | + | |Phase Shift Resolution((Not implemented as of November, 2017)) | 5.6 | deg | |
- | |< | + | |Input Voltage Noise(( Referenced to 50Ω load)) | TBD | nV/√Hz | |
^ Ramp Parameters ^ ^^ ^ | ^ Ramp Parameters ^ ^^ ^ | ||
- | |< | + | |Max. Ramp Amplitude | ±10 | V | |
^ Loop Filter Parameters ^ ^^ ^ | ^ Loop Filter Parameters ^ ^^ ^ | ||
- | |< | + | |DC Offset Range | ±10 | V | |
- | |< | + | |Proportional Gain (ref to DC Error) | -38 to +30 | dB | |
- | |< | + | |Proportional Gain Resolution | 2 | dB | |
- | |< | + | |First Integrator| |
- | |< | + | |Second Integrator| |
- | |< | + | |Differential| |
- | |< | + | |Differential Gain | 18 | dB | |
- | |< | + | |Output Range | ±10 | V | |
^ Output Control ^ ^^ ^ | ^ Output Control ^ ^^ ^ | ||
- | |< | + | |Adjustable Output Limits | ±10 | V | |
^Electrical Specifications^^^^^ | ^Electrical Specifications^^^^^ |
ice/servo-sc1.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1