| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
| ice:servo-peaklock [2016/07/21 16:50] – [Current Controller and Peak Lock Servo Board] Michael Radunsky | ice:servo-peaklock [2019/12/20 18:17] – [Specifications] Michael Radunsky |
|---|
| |<html> </html>Current range| 0-200 | 0-500 | mA | | |<html> </html>Current range| 0-200 | 0-500 | mA | |
| |<html> </html>Current setpoint resolution | 200 | 500 | μA | | |<html> </html>Current setpoint resolution | 200 | 500 | μA | |
| |<html> </html>Current noise density((All measurements guaranteed on design and verified experimentally on D2-105 which uses same circuit.))| <100 | <200 | pA / <HTML> √<span style="text-decoration: overline;">Hz</span> </HTML> | | |<html> </html>Current noise density((All measurements guaranteed on design and verified experimentally on D2-105 which uses same circuit.))| <100 | <200 | pA /√Hz | |
| |<html> </html>RMS Noise (10Hz - 100kHz)((All measurements guaranteed on design and verified experimentally on D2-105 which uses same circuit.))| <50 | <100 | nA | | |<html> </html>RMS Noise (10Hz - 100kHz)((All measurements guaranteed on design and verified experimentally on D2-105 which uses same circuit.))| <50 | <100 | nA | |
| |<html> </html>RMS Noise (10Hz - 1MHz)((All measurements guaranteed on design and verified experimentally on D2-105 which uses same circuit.))| <100 | <150 | nA | | |<html> </html>RMS Noise (10Hz - 1MHz)((All measurements guaranteed on design and verified experimentally on D2-105 which uses same circuit.))| <100 | <150 | nA | |
| |<html> </html>Dither Frequency | 4 || MHz | | |<html> </html>Dither Frequency | 4 || MHz | |
| |<html> </html>Phase Shift Resolution | 5.6 || deg | | |<html> </html>Phase Shift Resolution | 5.6 || deg | |
| |<html> </html>Input Voltage Noise(( Referenced to 50Ω load)) | TBD || nV/ <HTML> √<span style="text-decoration: overline;">Hz</span> </HTML> | | |<html> </html>Input Voltage Noise(( Referenced to 50Ω load)) | TBD || nV/√Hz | |
| ^ Loop Filter Parameters ^ ^^ ^ | ^ Loop Filter Parameters ^ ^^ ^ |
| |<html> </html>Proportional Gain (ref to DC Error) | -22 to +20 || dB | | |<html> </html>Proportional Gain (ref to DC Error) | -22 to +20 || dB | |
