User Tools

Site Tools


ice:servo-opls

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
ice:servo-opls [2019/11/18 23:30] – [Calculating Phase Noise] Michael Radunskyice:servo-opls [2019/11/18 23:33] – [Understanding the Transfer Function] Michael Radunsky
Line 90: Line 90:
  
  
-The charge pump in the OPLS outputs a signal proportional to the phase-error and the transfer function is as shown in <imgref xferfunc> However, the OPLS will typically be used to control a //frequency//-tunable device (such as a laser). In this configuration, the effective loop filter is not the one shown in <imgref opls_side_panel>, but includes a extra integration corresponding to converting the phase-error input to a frequency error. Thus, ω<sub> </sub>sets the frequency transition from single-integration to double-integration and ω<sub>I </sub> from single-integration to proportional feedback. It is important to understand this 'hidden' integrator when configuring the loop filter parameters. +The charge pump in the OPLS outputs a signal proportional to the phase-error and the transfer function is as shown in <imgref xferfunc> However, the OPLS will typically be used to control a //frequency//-tunable device (such as a laser). In this configuration, the effective loop filter is not the one shown in <imgref xferfunc>, but includes a extra integration corresponding to converting the phase-error input to a frequency error. Thus, ω<sub> </sub>sets the frequency transition from single-integration to double-integration and ω<sub>I </sub> from single-integration to proportional feedback. It is important to understand this 'hidden' integrator when configuring the loop filter parameters. 
  
 =====Calculating Phase Noise ===== =====Calculating Phase Noise =====
Line 96: Line 96:
 The phase-noise specified in Section 1.3 is referenced to the phase frequency detector (PFD) at 1 Hz. To convert that to the noise measured on the actual beat-note, it must be rescaled with the following formula: The phase-noise specified in Section 1.3 is referenced to the phase frequency detector (PFD) at 1 Hz. To convert that to the noise measured on the actual beat-note, it must be rescaled with the following formula:
  
-<WRAP center round box 450px> **D2-135 Phase-Noise Floor = -213 + 20Log(N) + 10Log(F<sub>REF</sub>)**</WRAP>+<WRAP center round box 450px> **D2-135 Phase-Noise Floor = -213 + 20Log(N) + 10Log(ƒ<sub>REF</sub>)**</WRAP>
  
-where N is the value of the divider and F<sub>REF</sub> is the reference frequency as measured in Hz. For more details, please see this [[http://www.vescent.com/2012/calculating-phase-noise-from-the-d2-135/|application note]].+where N is the value of the divider and ƒ<sub>REF</sub> is the reference frequency as measured in Hz. For more details, please see this [[http://www.vescent.com/2012/calculating-phase-noise-from-the-d2-135/|application note]].
  
  
ice/servo-opls.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1