ice:servo-opls
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ice:servo-opls [2019/11/18 23:30] – [Calculating Phase Noise] Michael Radunsky | ice:servo-opls [2019/11/18 23:31] – [Calculating Phase Noise] Michael Radunsky | ||
---|---|---|---|
Line 96: | Line 96: | ||
The phase-noise specified in Section 1.3 is referenced to the phase frequency detector (PFD) at 1 Hz. To convert that to the noise measured on the actual beat-note, it must be rescaled with the following formula: | The phase-noise specified in Section 1.3 is referenced to the phase frequency detector (PFD) at 1 Hz. To convert that to the noise measured on the actual beat-note, it must be rescaled with the following formula: | ||
- | <WRAP center round box 450px> **D2-135 Phase-Noise Floor = -213 + 20Log(N) + 10Log(F< | + | <WRAP center round box 450px> **D2-135 Phase-Noise Floor = -213 + 20Log(N) + 10Log(ƒ< |
- | where N is the value of the divider and F< | + | where N is the value of the divider and ƒ< |
ice/servo-opls.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1