Differences

This shows you the differences between two versions of the page.

--- ice:quadtemp [2014/07/22 20:11] – [I/O (OEM Only)] jtshugrue
+++ ice:quadtemp [2014/07/31 01:37] – external edit 127.0.0.1
@@ Line 101: / Line 101: @@
 </WRAP>
-The flat flex jumper cables used to connect to the FFC connectors should be 1.00mm pitch with 12 conductors. Another FFC connector must be used on the other side to break out the connections for OEM use. It should be noted that when connecting to the other side of the FFC, all the pin definitions will be reversed (i.e. pin 1 on one side will be pin 12 on the other). Generally with flat flex jumper cables, the cables can be folded but the bend radius should not be less that 2mm.
+The flat flex jumper cables used to connect to the FFC connectors should be 1.00mm pitch with 12 conductors. Another FFC connector must be used on the other side to break out the connections for OEM use. It should be noted that when connecting to the other side of the FFC, all the pin definitions will be reversed (i.e. pin 1 on one side will be pin 12 on the other).
+<WRAP center round info 60%>
+Generally with flat flex jumper cables, the cables can be folded but the bend radius should not be less that 2mm. The clearance in front of the pcb FFC connectors must be at least 0.25 inches to allow the flat flex cable to exit and bend. The distance between the FFC connector and the first bend of the flat flex cable is determined by the length of the stiffener (or backing) on the flat flex cable.
+</WRAP>
 ===== Quick Start Commands Guide =====