ice:oem_integration
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| ice:oem_integration [2014/07/22 20:13] – [Board Connections] jtshugrue | ice:oem_integration [2014/07/22 20:18] – [Board Connections] jtshugrue | ||
|---|---|---|---|
| Line 146: | Line 146: | ||
| <WRAP center round info 60%> | <WRAP center round info 60%> | ||
| - | Generally, the minimum bend radius for flat flex jumper cables is 2mm. Verify against the data sheet of the chosen flat flex jumper cable. | + | Generally, the minimum bend radius for flat flex jumper cables is 2mm. The length of the stiffener behind the exposed contacts on the cable will determine how far out from the FFC pcb connector the first bend of the flat flex cable can occur. The clearance for this bend must be accounted for when designing an enclosure for the ICE boards. For example, with Molex brand flat flex cables, there needs to be a minimum 0.25 inch clearance from the front of the flat flex pcb connector to allow the cable to bend. Verify against the data sheet of the chosen flat flex jumper cable. |
| </ | </ | ||
ice/oem_integration.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1