Differences

This shows you the differences between two versions of the page.

--- ice:master [2014/07/22 20:32] – [I/O] jtshugrue
+++ ice:master [2014/07/22 20:49] – [I/O] jtshugrue
@@ Line 76: / Line 76: @@
 === Serial & GPIO Connector ===
 Communication with the Master Controller and daughter modules is done through flat flex connecter J11 shown in <imgref pcbSchematic>. This connector contains two serial UART bi-directional communication busses, event system GPIO pins, and a safety interlock signal.
-J11 is a 12-pin 1.00mm pitch flat flex connector (FCI SFW12R-1STE1LF) with a pin definition shown in <tabref backpanelffc>.
+J11 is a 12-pin 1.00mm pitch flat flex connector (FCI SFW12R-1STE1LF) with a pin definition shown in <tabref backpanelffc>. Pin 1 is shown below in <imgref FFCpindef>.
+<imgcaption FFCpindef|Flat flex connector pin definition (pin 1 highlighted in yellow).>{{ :ice:sfw12r-1ste1lf_pin_diagram.jpg |}}</imgcaption>
 <WRAP>