Differences

This shows you the differences between two versions of the page.

--- ice:enclosure [2014/07/31 01:37] – external edit 127.0.0.1
+++ ice:enclosure [2014/08/01 16:27] – [I/O] Michael Radunsky
@@ Line 70: / Line 70: @@
-Power is provided with a mixed-signal D-Sub connector (Conec P/N: 3007W2PCM99A30X). Pin definition shown in <imgref powerConnector> and <tabref powerPinDef> above. The return current path for +5V_A is GND_A. This wiring connected to this return path should be capable of carrying the maximum current of the +5V_A line. The signals GND and GND_A are shorted together on the circuit board through a jumper, but this can be removed.
+Power is provided with a mixed-signal D-Sub connector ([[http://www.mouser.com/ProductDetail/CONEC/3007W2PCM99A30X/?qs=%2fha2pyFaduhkEoQ%252bOJK2seiwtqmu9Mu950NmOA%2fNXy1Mn5wO6DCIiQ%3d%3d|Conec P/N: 3007W2PCM99A30X]]). Pin definition shown in <imgref powerConnector> and <tabref powerPinDef> above. The return current path for +5V_A is GND_A. This wiring connected to this return path should be capable of carrying the maximum current of the +5V_A line. The signals GND and GND_A are shorted together on the circuit board through a jumper, but this can be removed.
 === USB ===
@@ Line 118: / Line 118: @@
 The safety interlock signal floats high to 3.3V and must be pulled down to ground to release the interlocks. This pin can safely be shorted to ground if safety interlock functionality is not required.
 </WRAP>