ice:commands:servo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ice:commands:servo [2017/10/27 17:40] – Michael Radunsky | ice:commands:servo [2017/10/27 17:47] – Michael Radunsky | ||
---|---|---|---|
Line 5: | Line 5: | ||
< | < | ||
- | Returns the phase shift (in degrees) on the dither signal modulating the laser current. | + | Returns the phase shift (in degrees) on the dither signal modulating the laser current.((Not implemented as of November, 2017)) |
< | < | ||
< | < | ||
- | Sets the phase shift to PHASE (in degrees) on the dither signal modulating the laser current. Returns the output of the command **Phase?** | + | Sets the phase shift to PHASE (in degrees) on the dither signal modulating the laser current. Returns the output of the command **Phase?**((Not implemented as of November, 2017)) |
< | < | ||
< | < | ||
- | Returns the amplitude of the dither on the laser current. Output is integer from 0-255. | + | Returns the amplitude of the dither on the laser current. Output is integer from 0-255.((Not implemented as of November, 2017)) |
< | < | ||
Line 25: | Line 25: | ||
< | < | ||
- | Enables or disables the dither on the laser current. Valid arguments are On or Off. Returns the output of the command **Dither? | + | Enables or disables the dither on the laser current. Valid arguments are On or Off. Returns the output of the command **Dither? |
< | < | ||
ice/commands/servo.txt · Last modified: 2023/12/06 20:44 by Christiana Sasser