ice:commands:quadtemp
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ice:commands:quadtemp [2018/12/17 23:07] – Michael Radunsky | ice:commands:quadtemp [2018/12/20 00:48] – Michael Radunsky | ||
---|---|---|---|
Line 4: | Line 4: | ||
< | < | ||
- | Returns the temperature setpoint for channel | + | Returns the temperature setpoint for channel |
- | < | + | |
< | < | ||
Line 13: | Line 12: | ||
//Note: temperature setpoint cannot be set outside of the bounds of the minimum and maximum temperature. | //Note: temperature setpoint cannot be set outside of the bounds of the minimum and maximum temperature. | ||
If TEMP is outside that range, temperature setpoint will not be adjusted.// | If TEMP is outside that range, temperature setpoint will not be adjusted.// | ||
- | < | ||
< | < | ||
- | Returns whether the temperature loop for channel CHANNEL is bipolar. | + | Returns whether the temperature loop for channel CHANNEL is bipolar. |
- | < | + | |
< | < | ||
Sets the temperature loop for channel CHANNEL bipolar (heating only) on or off. | Sets the temperature loop for channel CHANNEL bipolar (heating only) on or off. | ||
Turn Bipolar off when driving resistive heaters. Returns output from **BiPolar? | Turn Bipolar off when driving resistive heaters. Returns output from **BiPolar? | ||
- | < | ||
< | < | ||
Line 28: | Line 24: | ||
A return of fault means that the temperature is outside the min/max temperature range and that the | A return of fault means that the temperature is outside the min/max temperature range and that the | ||
temperature loop has been temporarily disabled. | temperature loop has been temporarily disabled. | ||
- | < | ||
< | < | ||
- | Turns the temperature servo loop for channel CHANNEL on or off. Returns the output of **Servo? | + | Turns the temperature servo loop for channel CHANNEL on or off. Returns the output of **Servo?** |
- | < | + | |
< | < | ||
Returns the current temperature for channel CHANNEL. | Returns the current temperature for channel CHANNEL. | ||
- | < | ||
< | < | ||
- | Returns the temperature error (T< | + | Returns the temperature error (T< |
< | < | ||
ice/commands/quadtemp.txt · Last modified: 2023/12/06 20:27 by Christiana Sasser