ice:commands:overview
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| ice:commands:overview [2013/12/04 22:25] – Ben Luey | ice:commands:overview [2016/06/03 16:00] – [Sample Conversion] fix typo and on/off inversion Ben Luey | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| are commands for the master. Any command that does not start with "#" | are commands for the master. Any command that does not start with "#" | ||
| that the master is talking to. The **#Slave** command shows/sets what slot (1-8) the master board is talking to. | that the master is talking to. The **#Slave** command shows/sets what slot (1-8) the master board is talking to. | ||
| + | |||
| + | ===== Sample Conversation ===== | ||
| For example, let's say you have a Quad Temp board in Slot 2 and a Peak Lock Servo & Current Controller | For example, let's say you have a Quad Temp board in Slot 2 and a Peak Lock Servo & Current Controller | ||
| Line 24: | Line 26: | ||
| SetTemp 3 24.56 | SetTemp 3 24.56 | ||
| 24.56 | 24.56 | ||
| - | Bipolar 3 On | + | Bipolar 3 Off |
| - | | + | |
| #Slave 5 | #Slave 5 | ||
| Laser Off | Laser Off | ||
| Line 45: | Line 47: | ||
| | Ok, the laser is now off (Peak Lock in Slot 5)| | | Ok, the laser is now off (Peak Lock in Slot 5)| | ||
| + | |||
| + | ===== Sample Command Description ===== | ||
| The documentation for every command will look like the example below: | The documentation for every command will look like the example below: | ||
ice/commands/overview.txt · Last modified: 2023/11/30 21:29 by 127.0.0.1