Differences

This shows you the differences between two versions of the page.

--- ice:commands:opls [2016/07/21 23:30] – Michael Radunsky
+++ ice:commands:opls [2016/07/21 23:34] – Michael Radunsky
@@ Line 77: / Line 77: @@
 <function=ICEfunc|0=RampSwp&1=F:VOLTAGE:2.64&2=2.65&3=48>
-Writes the sweep range (in volts) for the ramp. Range is from -0V to +10V. Returns the output from the command **RampSwp?**.  The ramp will sweep from SvOffst - RampSwp/2 to SvOffst + RampSwp/2 and then return to SvOffst every time a RampRun command is initiatied.\\
+Writes the sweep range (in volts) for the ramp. Range is from -0V to +10V. Returns the output from the command **RampSwp?**.  The ramp will step from SvOffst - RampSwp/2 to SvOffst + RampSwp/2 by increments determined by RampSwp and RampNum and then return to SvOffst every time a RampRun command is initiated.\\
 \\
 //Note: RampSwp value is rounded and truncated to match range of the servo offset. //