ice:commands:lasercurrent
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
ice:commands:lasercurrent [2013/12/16 22:44] – Ben Luey | ice:commands:lasercurrent [2023/11/30 21:29] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 3: | Line 3: | ||
List of common commands for controlling the laser controller in both the Peak Lock Servo and Peak Lock Servo & Current Controller and the Offset Phase Lock Servo & Current Controller. | List of common commands for controlling the laser controller in both the Peak Lock Servo and Peak Lock Servo & Current Controller and the Offset Phase Lock Servo & Current Controller. | ||
- | < | + | < |
Returns the status of the laser (on, off or fault). | Returns the status of the laser (on, off or fault). | ||
< | < | ||
- | < | + | < |
Turns the laser on or off. Valid arguments are ON or OFF. Only turns the laser on when no fault / interlock issues. Returns the output from the Laser? command. | Turns the laser on or off. Valid arguments are ON or OFF. Only turns the laser on when no fault / interlock issues. Returns the output from the Laser? command. | ||
< | < | ||
- | < | + | < |
Returns the laser current setpoint (in mA) for how much current will flow through the laser when the laser is on. < | Returns the laser current setpoint (in mA) for how much current will flow through the laser when the laser is on. < | ||
- | < | + | < |
Sets the setpoint laser current (in mA) to CURRENT. Returns the output from the **CurrSet? | Sets the setpoint laser current (in mA) to CURRENT. Returns the output from the **CurrSet? | ||
< | < | ||
- | < | + | < |
Returns the current limit (in mA) for the maximum current allowed to flow through the laser when the laser is on. | Returns the current limit (in mA) for the maximum current allowed to flow through the laser when the laser is on. | ||
< | < | ||
- | < | + | < |
Sets the maximum laser current to CURRENT. Returns the output from the **CurrLim? | Sets the maximum laser current to CURRENT. Returns the output from the **CurrLim? | ||
//Note: If Laser Current is set above new current limit value, then current setpoint is lowered to new current limit value.// | //Note: If Laser Current is set above new current limit value, then current setpoint is lowered to new current limit value.// | ||
< | < | ||
ice/commands/lasercurrent.1387233899.txt.gz · Last modified: 2021/08/26 14:26 (external edit)