Differences

This shows you the differences between two versions of the page.

--- ice:commands:lasercurrent [2013/12/16 21:54] – created Ben Luey
+++ ice:commands:lasercurrent [2023/11/30 21:29] (current) – external edit 127.0.0.1
@@ Line 3: / Line 3: @@
 List of common commands for controlling the laser controller in both the Peak Lock Servo and Peak Lock Servo & Current Controller and the Offset Phase Lock Servo & Current Controller.
-<function=ICEfunc|0=Laser?&2=On&3=16>
+<function=ICEfunc?0=Laser?&2=On&3=16>
 Returns the status of the laser (on, off or fault).
 <html></div></html>
-<function=ICEfunc|0=Laser&1=A:On/Off:On&2=Fault&3=16>
+<function=ICEfunc?0=Laser&1=A:On/Off:On&2=Fault&3=17>
 Turns the laser on or off. Valid arguments are ON or OFF. Only turns the laser on when no fault / interlock issues. Returns the output from the Laser? command.
 <html></div></html>
+<function=ICEfunc?0=CurrSet?&2=147.6&3=18>
+Returns the laser current setpoint (in mA) for how much current will flow through the laser when the laser is on. <html></div></html>
+<function=ICEfunc?0=CurrSet&1=F:CURRENT:123.52&2=123.5&3=19>
+Sets the setpoint laser current (in mA) to CURRENT. Returns the output from the **CurrSet?** command.
+<html></div></html>
+<function=ICEfunc?0=CurrLim?&2=180.0&3=20>
+Returns the current limit (in mA) for the maximum current allowed to flow through the laser when the laser is on.
+<html></div></html>
+<function=ICEfunc?0=CurrLim&1=F:CURRENT:156&2=156&3=21>
+Sets the maximum laser current to CURRENT. Returns the output from the **CurrLim?** command.
+//Note: If Laser Current is set above new current limit value, then current setpoint is lowered to new current limit value.//
+<html></div></html>