Product Manuals

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Common Commands to all ICE Slave Boards =====

This following commands are common to all slave boards:

<function=ICEfunc?0=EnumDev&2=0 1 1 1 25&3=0>
Enumerate device. Returns the device type ID, feature set, command set revision, number of supported commands and an internal number. In general, this command is only used internally by the Master board.
<html></div></html>

<function=ICEfunc?0=Reset&1=I:SYSTEM:1&2=Success&3=2>
Resets the ICE board to initial power on conditions. If SYSTEM is 0, resets to the saved EEPROM settings. If SYSTEM is 1, resets to factory default settings.
<html></div></html>

<function=ICEfunc?0=Status&2=Busy&3=5>
Returns the status (Ready, Busy) of the ICE board.
<html></div></html>

<function=ICEfunc?0=Abort&3=6>
Tells ICE board to abort the long-running command it is currently executing.
<html></div></html>

<function=ICEfunc?0=ReadBlk&1=I:BLOCK:5&2=0x34 0x7A 0x2D 0xB4 0x83 0x1D 0xAE 0x29&3=8>
Reads the specified data block from the ICE board data buffer. Returns 8 bytes starting at BLOCK address.
See individua ICE board for structure of the data.
<html></div></html>

<function=ICEfunc?0=Save&2=Success&3=10>
Saves the board’s current settings into EEPROM. Unsaved changes will be lost when the board is powered off. Returns SUCCESS or FAIL.
<html></div></html>

<function=ICEfunc?0=Version&2=6 1 5 2 5 1 56 76&3=13>
Returns various versions of the board (hardware, firmware) and serial number in raw form. Use the Master's #Version BoardNumber command to return this information with nicer formatting. 
<html></div></html>