ice:commands:common
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
ice:commands:common [2014/07/31 01:37] – external edit 127.0.0.1 | ice:commands:common [2015/04/29 23:18] – Fixed typo for "version" command jtshugrue | ||
---|---|---|---|
Line 4: | Line 4: | ||
< | < | ||
- | Enumerate device. Returns the device ID, firmware revision (major and minor), hardware revision, command set revision, | + | Enumerate device. Returns the device |
< | < | ||
- | < | + | < |
- | Resets the ICE board to initial power on conditions. | + | Resets the ICE board to initial power on conditions. If SYSTEM is 0, resets to the saved EEPROM settings. If SYSTEM is 1, resets to factory default settings. |
< | < | ||
Line 28: | Line 28: | ||
< | < | ||
- | < | + | < |
- | Resets all the boards settings to the default values. Does not save these changes. If you want to board boot to the default values, after running **DEFAULT** run **SAVE** | + | Returns various versions of the board (hardware, firmware) and serial number in raw form. Use the Master' |
< | < | ||
ice/commands/common.txt · Last modified: 2023/11/30 21:29 by 127.0.0.1