Differences

This shows you the differences between two versions of the page.

--- ice:commands:common [2013/12/06 23:42] – Ben Luey
+++ ice:commands:common [2014/02/20 22:56] – Ben Luey
@@ Line 7: / Line 7: @@
 <html></div></html>
-<function=ICEfunc|0=Reset&3=1>
+<function=ICEfunc|0=Reset&3=2>
 Resets the ICE board to initial power on conditions.
 <html></div></html>
-<function=ICEfunc|0=Status&2=Busy&3=2>
+<function=ICEfunc|0=Status&2=Busy&3=5>
 Returns the status (Ready, Busy) of the ICE board.
 <html></div></html>
-<function=ICEfunc|0=Abort&3=3>
+<function=ICEfunc|0=Abort&3=6>
 Tells ICE board to abort the long-running command it is currently executing.
 <html></div></html>
-<function=ICEfunc|0=ReadBlk&1=I:BLOCK:5&2=0x34 0x7A 0x2D 0xB4 0x83 0x1D 0xAE 0x29&3=4>
+<function=ICEfunc|0=ReadBlk&1=I:BLOCK:5&2=0x34 0x7A 0x2D 0xB4 0x83 0x1D 0xAE 0x29&3=8>
 Reads the specified data block from the ICE board data buffer. Returns 8 bytes starting at BLOCK address.
 See individua ICE board for structure of the data.
 <html></div></html>
-<function=ICEfunc|0=Save&2=Success&3=5>
+<function=ICEfunc|0=Save&2=Success&3=10>
 Saves the board’s current settings into EEPROM. Unsaved changes will be lost when the board is powered off. Returns SUCCESS or FAIL.
 <html></div></html>
+<function=ICEfunc|0=Defaults&2=Success&3=11>
+Resets all the boards settings to the default values. Does not save these changes. If you want to board boot to the default values, after running **DEFAULT** run **SAVE** to store that default values. Returns SUCCESS or FAIL.
+<html></div></html>