Differences

This shows you the differences between two versions of the page.

--- ffc:comb_module_quickstart [2022/04/01 15:57] – external edit 127.0.0.1
+++ ffc:comb_module_quickstart [2022/04/01 15:58] – external edit 127.0.0.1
@@ Line 96: / Line 96: @@
 Finally, go back to the FPGA Software folder in your file explorer and run both "FrontPanelUSB-Win-x64-4.5.6", and "vcredist_x64". Each will open their own installer. Follow the instructions on both and click finish. When both are done installing, your computer should be configured to run the FPGA software.
 =====Locking the SVS FFC Module=====
-Before locking, it may be beneficial to familiarize yourself with the full list of API commands for the SVS FFC Module, which can be found [[ffc:cm:api-osc|here]], as well as the front and rear panel connections, which can be found [[link|here]]. It is also important to note that, aside from those set in the FPGA software, all PID parameters come preset and should not need to be adjusted.
+Before locking, it may be beneficial to familiarize yourself with the full list of API commands for the SVS FFC Module, which can be found [[ffc:cm:api-osc|here]], as well as the front and rear panel connections, which can be found in Figure 8. It is also important to note that, aside from those set in the FPGA software, all PID parameters come preset and should not need to be adjusted.
 ===Connections===