Differences

This shows you the differences between two versions of the page.

--- ffc:cm:quickstart [2021/12/09 17:27] – external edit 127.0.0.1
+++ ffc:cm:quickstart [2021/12/14 18:23] (current) – external edit 127.0.0.1
@@ Line 185: / Line 185: @@
 </WRAP>
-If satisfied that the output power of the pump diodes is safe, ensure that the pump fiber ends are clean using a fiber cleaner, then connect the OSC Out (Pump 1) and any EDFA Amplifiers (Pumps 2 and 3) on the Pump Diode Board to the FFC-CM as shown in <imgref Diagram>. If you're using the 1556nm system, there will only be one amplifier pump diode. If you're using the 778nm system, there will be two amplifier pump diodes.
+If satisfied that the output power of the pump diodes is safe, ensure that the pump fiber ends are clean using a fiber cleaner, then connect the oscillator pump and amplifier pump(s) on the Pump Diode Board to the FFC-CM as shown in <imgref Diagram>. If you're using the 1556nm system, there will only be one amplifier pump diode. If you're using the 778nm system, there will be two amplifier pump diodes.
 ===Step 3: Power and Connect CW Laser===