Differences

This shows you the differences between two versions of the page.

--- fcc:100:api [2021/10/18 23:02] – external edit 127.0.0.1
+++ fcc:100:api [2021/10/18 23:17] – external edit 127.0.0.1
@@ Line 42: / Line 42: @@
 For most complete version of API, download the FFC-Serial API PDF from the [[fcc:100:api#Links|downloads]] section.
-=====New Table=====
+=====General Commands=====
 <function=ICEfunc|0=#Version&1=&2=255.255 255.255 0.16 65535 (0.16 is version)&-1>
 Returns firmware version of master board where arguments are used as follows:
@@ Line 65: / Line 65: @@
 Sets the touch screen and rotary knob audio feedback volume
 ----
-<function=ICEfunc|0=*IDN?&1=&2=Vescent Photonics,FFC,[serial#],S-[version],FL-[version],LD-[version],LD-[version]&-1>
+<function=ICEfunc|0= *IDN?&1=&2=Vescent Photonics,FFC,[serial#],S-[version],FL-[version],LD-[version],LD-[version]&-1>
 Returns the Manufacturer, Model, Serial Number, Board Firmware Versions  of the device
 ----
-<function=ICEfunc|0=*RST&1=&2=Resetting System&-1>
+<function=ICEfunc|0= *RST&1=&2=Resetting System&-1>
 Restarts the device (power cycle)
 ----
@@ Line 79: / Line 79: @@
-=====New Table=====
+=====Control API=====
 <function=ICEfunc|0=MSTRCTL?&1=&2=MSTRCTL? 0&-1>
 Returns the enumerated operating mode of the FFC
@@ Line 163: / Line 163: @@
-=====FFC Temperature Controls=====
+=====Temperature Controls=====
 <function=ICEfunc|0=CATSETP?&1=&2=CATSETP? 20.3&-1>
 Returns the temperature setpoint for the Cavity Temperature Control
@@ Line 657: / Line 657: @@
-=====New Table=====
+=====Laser Current Controls=====
 <function=ICEfunc|0=OSISETP?&1=&2=OSISETP? 997.939941&-1>
 Reads the Current Setpoint for the Oscillator Laser [mA]
@@ Line 772: / Line 772: @@
-=====New Table=====
+=====Laser PZT Controls=====
 <function=ICEfunc|0=CADCBSP?&1=&2=CADCBSP? 60.000000&-1>
 Reads the DC Bias Setpoint for the Cavity [V]