d2:spectroscopy_module_210
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
d2:spectroscopy_module_210 [2016/08/31 10:40] – [Inputs, Outputs, and Controls] Michael Radunsky | d2:spectroscopy_module_210 [2019/06/18 20:48] – [Aligning the Spectroscopy Module] Michael Radunsky | ||
---|---|---|---|
Line 27: | Line 27: | ||
* D2-210 Spectroscopy Module | * D2-210 Spectroscopy Module | ||
* VPN00463 SMA cable (6ft) | * VPN00463 SMA cable (6ft) | ||
- | Also look for: | ||
* VPN00410 Hirose-to-D Sub 9-pin (shipped under separate line item; specify for use with D2) | * VPN00410 Hirose-to-D Sub 9-pin (shipped under separate line item; specify for use with D2) | ||
* VPN00475 Hirose-to-Hirose power cord (shipped under separate line item; specify for use with ICE) | * VPN00475 Hirose-to-Hirose power cord (shipped under separate line item; specify for use with ICE) | ||
+ | * VPN00367 Adjustment tool | ||
Line 45: | Line 45: | ||
=====Specifications===== | =====Specifications===== | ||
<WRAP center round box 500px>< | <WRAP center round box 500px>< | ||
- | ^ ^ Value ^ Units ^ | + | ^ ^ Value ^ Units |
- | ^**Input Light Level** | + | ^ **Input Light Level** |
- | ^**Photodiode Amplifier** | + | ^ **Photodiode Amplifier** |
- | | < | + | | Transimpedance (signal) |
- | | < | + | | Bandwidth (signal) |
- | | < | + | | Noise @ 5 MHz | < |
- | ^Set Temperature | + | ^ Set Temperature |
- | ^Temperature Stability| | + | ^ Temperature Stability |
- | ^Beam Height| | + | ^ Beam Height |
- | ^Total package Size \\ (L x W x H)| 3.6 x 5 x 1.7 | inches | + | ^ Total package Size \\ (L x W x H) | 3.6 x 5 x 1.7 | inches |
</ | </ | ||
</ | </ | ||
Line 78: | Line 78: | ||
**Input Connector**** (****6-pin circular)** | **Input Connector**** (****6-pin circular)** | ||
+ | <WRAP center round important 60%> | ||
+ | </ | ||
- | Power and temperature control signals from the D2-series power bus or other power supply are made through a 6-pin circular connector ([[http:// | + | Power and temperature control signals from the D2-series power bus, the ICE-PB1, |
< | < | ||
Line 188: | Line 190: | ||
- | The following images are representative of spectroscopy for < | + | The following images are representative of spectroscopy for < |
+ | < | ||
- | {{ : | + | < |
- | {{ : | + | < |
d2/spectroscopy_module_210.txt · Last modified: 2024/03/27 15:58 by Thomas Bersano