Differences

This shows you the differences between two versions of the page.

--- d2:spectroscopy_module_210 [2016/08/31 10:40] – [Inputs, Outputs, and Controls] Michael Radunsky
+++ d2:spectroscopy_module_210 [2019/01/24 02:39] – [Table] Michael Radunsky
@@ Line 45: / Line 45: @@
 =====Specifications=====
 <WRAP center round box 500px><tabcaption specs>
-^ ^  Value  ^  Units  ^
+^                                    ^  Value          ^  Units   ^
-^**Input Light Level**  |  2< P <1000  |  mW  |
+^ **Input Light Level**              |  2< P <1000     |  mW      |
-^**Photodiode Amplifier**  |    |    |
+^ **Photodiode Amplifier**           |                 |          |
-| <html> &nbsp;&nbsp; </html>  Transimpedance (signal) |  40,000  |  Ω  |
+| Transimpedance (signal)            |  40,000         |  Ω       |
-| <html> &nbsp;&nbsp; </html>Bandwidth (signal) |  5  |  MHz  |
+| Bandwidth (signal)                 |  5              |  MHz     |
-| <html> &nbsp;&nbsp; </html>Noise @ 5 MHz  |  <80  |  nV / <HTML> √<span style="text-decoration: overline;">Hz</span></HTML> |
+| Noise @ 5 MHz                      |  <80            |  nV /√Hz |
-^Set Temperature  |  ~25 to 65  |  °C  |
+^ Set Temperature                    |  ~25 to 65      |  °C      |
-^Temperature Stability|  <0.1  |  °C  |
+^ Temperature Stability              |  <0.1           |  °C      |
-^Beam Height|  0.95  |  inches  |
+^ Beam Height                        |  0.95           |  inches  |
-^Total package Size \\ (L x W x H)|  3.6 x 5 x 1.7  |  inches  |
+^ Total package Size \\ (L x W x H)  |  3.6 x 5 x 1.7  |  inches  |
 </tabcaption>
 </WRAP>
@@ Line 78: / Line 78: @@
 **Input Connector**** (****6-pin circular)**
+<WRAP center round important 60%>Never connect this device to its power supply when the power supply is switched on and supplying power.  Always turn off the power supply, make connections to the device, and then re-energize the power supply.
+</WRAP>
-Power and temperature control signals from the D2-series power bus or other power supply are made through a 6-pin circular connector ([[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TR-6SA(73)&WT.z_header=search_go|HR10A-7TR-6SA(73)]]).  The pin definitions (pin numbers are marked on the connectors) are listed below.  <imgref image1> below may be useful.
+Power and temperature control signals from the D2-series power bus, the ICE-PB1, or other power supply are made through a 6-pin circular connector ([[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TR-6SA(73)&WT.z_header=search_go|HR10A-7TR-6SA(73)]]).  The pin definitions (pin numbers are marked on the connectors) are listed below.  <imgref image1> below may be useful.
 <imgcaption image1|Pin numbering on female Hirose 6-pin connector>{{  :d2:d2-160:hirose-connector.png?200  }}</imgcaption>