d2:quick_start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
d2:quick_start [2016/10/06 23:29] – [Setting Up the Oscilloscope for Locking.] Michael Radunsky | d2:quick_start [2021/08/26 15:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 4: | Line 4: | ||
</ | </ | ||
Document Last Updated on ~~LASTMOD~~ | Document Last Updated on ~~LASTMOD~~ | ||
- | |||
===== Electronic Modules Initial Setup ===== | ===== Electronic Modules Initial Setup ===== | ||
Line 31: | Line 30: | ||
===== Cabling & Power ===== | ===== Cabling & Power ===== | ||
+ | <WRAP center round important 60%> | ||
+ | |||
+ | Never connect any device to the D2-005 power supply when it is switched on and supplying power. | ||
+ | </ | ||
Locate the 6 ft connector cable assembly with SMA connectors on both ends. Plug the SMA connector into the LASER CURRENT OUTPUT plug and the Hirose connector into the LASER TEMP OUTPUT on the Laser Controller. Make sure that the nearby Laser switch is in the OFF/RESET position (down). While grounded, remove the SMA terminator connected to the Laser. Connect the other end of the SMA cable and Hirose connectors to the DBR module. | Locate the 6 ft connector cable assembly with SMA connectors on both ends. Plug the SMA connector into the LASER CURRENT OUTPUT plug and the Hirose connector into the LASER TEMP OUTPUT on the Laser Controller. Make sure that the nearby Laser switch is in the OFF/RESET position (down). While grounded, remove the SMA terminator connected to the Laser. Connect the other end of the SMA cable and Hirose connectors to the DBR module. |
d2/quick_start.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1