Product Manuals

User Tools

Site Tools

You are here: manuals » d2 » quick_start
d2:quick_start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
d2:quick_start [2016/10/06 23:29] – [Setting Up the Oscilloscope for Locking.] Michael Radunskyd2:quick_start [2017/10/12 00:48] – [Cabling & Power] Michael Radunsky
Line 31: Line 31:
  
 ===== Cabling & Power ===== ===== Cabling & Power =====
 +<WRAP center round important 60%>Never connect or disconnect the D2-105 to/from a laser with the D2-105 energized.  Always power down the D2-105 completely before making connections to the laser.
 +
 +Never connect any device to the D2-005 power supply when it is switched on and supplying power.  Always turn off the power supply, make connections to the devices, and then re-energize the power supply.
 +</WRAP>
  
 Locate the 6 ft connector cable assembly with SMA connectors on both ends. Plug the SMA connector into the LASER CURRENT OUTPUT plug and the Hirose connector into the LASER TEMP OUTPUT on the Laser Controller. Make sure that the nearby Laser switch is in the OFF/RESET position (down). While grounded, remove the SMA terminator connected to the Laser. Connect the other end of the SMA cable and Hirose connectors to the DBR module. Locate the 6 ft connector cable assembly with SMA connectors on both ends. Plug the SMA connector into the LASER CURRENT OUTPUT plug and the Hirose connector into the LASER TEMP OUTPUT on the Laser Controller. Make sure that the nearby Laser switch is in the OFF/RESET position (down). While grounded, remove the SMA terminator connected to the Laser. Connect the other end of the SMA cable and Hirose connectors to the DBR module.
d2/quick_start.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1