This is an old revision of the document!
Table of Contents
Power Supply
Model No. D2-005
Document Revision: 1
Document Last Updated on 2021/08/26 14:26
Please read Limited Warranty and General Warnings and Cautions prior to operating the D2-105.
Description
The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules.
Absolute Maximum Ratings
Note: All modules designed to be operated in laboratory environment
Parameter | Rating |
Environmental Temperature | >15°C and <30°C |
Environmental Humidity | <60% |
Environmental Dew Points | <15°C |
Specifications
Units | ||
---|---|---|
Current Limit | ||
<html> </html>+15V | 1.5 | A |
<html> </html>-15V | 1.5 | A |
<html> </html>+5V | 6 | A |
Output Regulation | 0.05 | % |
Inputs, Outputs, and Controls
Monitor Section
The monitor section contains three blue status LEDs indicating proper voltage on the +15,-15, and 5V power lines. In there is a voltage sag on any of the power lines, the blue status LED will turn off.
Back panel I/O
Power I/O (9-pin D-sub)
The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit. The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels. The pin outs are shown in the following figure: