Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
d2:offset_phase_lock_servo [2019/11/19 18:26] – [Calculating Phase Noise] Michael Radunsky | d2:offset_phase_lock_servo [2019/11/20 02:01] – [Options] Michael Radunsky |
---|
The D2-135 comes in two different versions: | The D2-135 comes in two different versions: |
| |
*//D2-135-SMA - //SMA input of the electrical beat-note | *//D2-135-SMA// SMA input of the electrical beat-note |
*//D2-135-FC-800// - Fiber-input of optical beat-note for wavelengths 750nm - 870nm (obsolete) | *//D2-135-FC-800// - Fiber-input of optical beat-note for wavelengths 750nm - 870nm (obsolete) |
| |
The D2-135-SMA requires an electrical signal input between 10 and -10 dBm of power. | The D2-135-SMA requires an electrical signal input between 10 and -10 dBm of power. |
| |
The D2-135-FC-800 is no longer available, but information regarding it is retained for those users who have purchased this model. It includes a 10 GHz GaAs high-speed photo-detector for converting the input optical beat-note into a electrical beat-note. The maximum optical input power is 1 mW. //Warning: input powers over 1mW of optical power can damage the OPLS.// A minimum of 50 μW of power in the optical beat-note is required(( Note the power in the beat-note is not the same as total power. Because the optical input uses multi-mode fiber, the spatial mode overlap between the two lasers is not guaranteed. If the overlap between the two lasers is poor, there can be very little power in the beat-note despite large optical power. )). | The D2-135-FC-800 is no longer available, but information regarding it is retained for those users who have purchased this model. It includes a 10 GHz GaAs high-speed photo-detector for converting the input optical beat-note into a electrical beat-note. The maximum optical input power is 1 mW. //Warning: input powers over 1mW of optical power can damage the internal photodetector.// A minimum of 50 μW of power in the optical beat-note is required(( Note the power in the beat-note is not the same as total power. Because the optical input uses multi-mode fiber, the spatial mode overlap between the two lasers is not guaranteed. If the overlap between the two lasers is poor, there can be very little power in the beat-note despite large optical power. )). |
===== Absolute Maximum Ratings ===== | ===== Absolute Maximum Ratings ===== |
Note: All modules designed to be operated in laboratory environment | Note: All modules designed to be operated in laboratory environment |