Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
d2:offset_phase_lock_servo [2018/12/05 16:35] – [Understanding the Transfer Function] Michael Radunsky | d2:offset_phase_lock_servo [2019/11/20 01:59] – [Options] Michael Radunsky |
---|
Please read [[:limited_warranty|Limited Warranty]] and [[:warnings_cautions|General Warnings and Cautions]] prior to operating the D2-135. | Please read [[:limited_warranty|Limited Warranty]] and [[:warnings_cautions|General Warnings and Cautions]] prior to operating the D2-135. |
| |
[[d2:quick_start_opls|A quick-start guide]] is available for the D2-135. | [[d2:quick_start_opls|A quick-start guide]] is available for the D2-135.\\ |
| [[https://www.vescent.com/products/electronics/d2-135-offset-phase-lock-servo/|D2-135 Web page]] |
=====Description===== | =====Description===== |
| |
The D2-135 comes in two different versions: | The D2-135 comes in two different versions: |
| |
*//D2-135-SMA - //SMA input of the electrical beat-note | *//D2-135-SMA// SMA input of the electrical beat-note |
*//D2-135-FC-800// - Fiber-input of optical beat-note for wavelengths 750nm - 870nm (obsolete) | *//D2-135-FC-800// - Fiber-input of optical beat-note for wavelengths 750nm - 870nm (obsolete) |
| |
=====Calculating Phase Noise ===== | =====Calculating Phase Noise ===== |
| |
The phase-noise specified in Section 1.3 is referenced to the phase frequency detector (PFD) at 1 Hz. To convert that to the noise measured on the actual beat-note, it must be rescaled with the following formula: | The phase-noise specified in the [[d2:offset_phase_lock_servo#specifications|Specifications]] above is referenced to the phase frequency detector (PFD) at 1 Hz. To convert that to the noise measured on the actual beat-note, it must be rescaled with the following formula: |
| |
''D2-135 Phase-Noise Floor = -213 + 20Log(N) + 10Log(F<sub>REF</sub>)'' | ''D2-135 Phase-Noise Floor = -213 + 20Log(N) + 10Log(F<sub>REF</sub>)'' |
| |
| |
where N is the value of the divider and F<sub>REF</sub> is the reference frequency as measured in Hz. For more details, please see [[http://www.vescent.com/2012/calculating-phase-noise-from-the-d2-135/|http://www.vescent.com/2012/calculating-phase-noise-from-the-d2-135/]] . | where N is the value of the divider and F<sub>REF</sub> is the reference frequency as measured in Hz. For more details, please see [[http://www.vescent.com/2012/calculating-phase-noise-from-the-d2-135/|Calculating Phase Noise from the D2-135]]. |
| |
=====Help ===== | =====Help ===== |