User Tools

Site Tools


d2:offset_phase_lock_servo

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
d2:offset_phase_lock_servo [2020/03/06 01:51]
Michael Radunsky [Right Side Panel]
d2:offset_phase_lock_servo [2021/04/26 22:21] (current)
Line 281: Line 281:
 **VCO Freq. Adjust** **VCO Freq. Adjust**
  
-This input is summed in with the VCO TUNE potentiometer to set the voltage to the VCO, and thus the reference frequency when the OPLS is using the internal VCO. The impedance to this input in 1 kΩ and can accept voltages from -10V to +10V and should tune over entire VCO range, provided that the VCO TUNE potentiometer is set in the middle of the VCO range. +This input is summed in with the VCO TUNE potentiometer to set the voltage applied to the VCO, and thus the reference frequency when the OPLS is using the internal VCO. The impedance of this input is 1 kΩ and it can accept voltages from -10V to +10V which will tune the reference frequency over the entire VCO range, provided that the VCO TUNE potentiometer is set in the middle of its range. 
  
 =====Understanding Gain in the OPLS===== =====Understanding Gain in the OPLS=====
d2/offset_phase_lock_servo.txt · Last modified: 2021/04/26 22:21 (external edit)