d2:laser_servo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
d2:laser_servo [2020/03/18 16:39] – [Right Side Panel] Michael Radunsky | d2:laser_servo [2021/03/02 17:06] – [Specifications] Michael Radunsky | ||
---|---|---|---|
Line 67: | Line 67: | ||
<WRAP center round box 600px> | <WRAP center round box 600px> | ||
| | **Value** | | | **Value** | ||
- | | **Input and Output Impedance** | + | | **Input and Output Impedance** |
| **Output Voltage (main and aux)** | | **Output Voltage (main and aux)** | ||
| **Input Voltage Noise**(( Referenced to 50Ω load)) | | **Input Voltage Noise**(( Referenced to 50Ω load)) | ||
Line 320: | Line 320: | ||
**Absolute Jump TTL (BNC)** | **Absolute Jump TTL (BNC)** | ||
- | When asserted HIGH (5V) while in LOCK mode, ABSOLUTE JUMP takes the Laser Servo out of lock and conveys the voltage on LASER JUMP AMPLITUDE to the SERVO OUTPUT. | + | When asserted HIGH (5V) while in LOCK mode, ABSOLUTE JUMP takes the Laser Servo out of lock and conveys |
- | When asserted HIGH (5V) while in RAMP mode, ABSOLULTE | + | When asserted HIGH (5V) while in RAMP mode, ABSOLUTE |
- | When disconnected, | + | When disconnected, |
**Relative Jump TTL (BNC)** | **Relative Jump TTL (BNC)** | ||
- | When asserted HIGH (5 V) while in LOCK mode, RELATIVE JUMP engages a sample-and-hold circuit and takes the Laser Servo out of lock. The voltage on the SERVO OUTPUT is the sample-and-hold value summed in with the LASER JUMP AMPLITUDE. For example, if the laser is locked and the SERVO OUTPUT is -200 mV, then engaging the RELATIVE JUMP and putting 300 mV on the LASER JUMP AMPLITUDE will make the SERVO OUTPUT | + | When asserted HIGH (5 V) while in LOCK mode, RELATIVE JUMP engages a sample-and-hold circuit and takes the Laser Servo out of lock. The voltage on the SERVO OUTPUT is the sample-and-hold value summed in with <color black/ |
When asserted HIGH (5V) while in RAMP mode, RELATIVE JUMP applies a DC offset equal to the LASER JUMP AMPLITUDE to the ramp signal at SERVO OUTPUT. When asserted LOW (0V) while in RAMP mode, the ramp signal is DC balanced. | When asserted HIGH (5V) while in RAMP mode, RELATIVE JUMP applies a DC offset equal to the LASER JUMP AMPLITUDE to the ramp signal at SERVO OUTPUT. When asserted LOW (0V) while in RAMP mode, the ramp signal is DC balanced. |
d2/laser_servo.txt · Last modified: 2021/12/17 01:58 by 127.0.0.1