d2:laser_servo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
d2:laser_servo [2020/03/16 22:21] – [Description] Michael Radunsky | d2:laser_servo [2020/03/18 16:39] – [Right Side Panel] Michael Radunsky | ||
---|---|---|---|
Line 267: | Line 267: | ||
** Aux: Bipolar / Aux: Unipolar (2-position slider switch) ** | ** Aux: Bipolar / Aux: Unipolar (2-position slider switch) ** | ||
- | This 2-position slider switch is only accessible by removing the right side panel (see above) and sets whether the AUXILIARY OUTPUT SERVO is unipolar or bipolar. It is factory set to be bipolar so the auxiliary output can range from -12 V to +12 V. For some applications such as driving a PZT, limiting the voltage range to positive values is necessary. | + | This 2-position slider switch is only accessible by removing the right side panel (see above) and sets whether the AUXILIARY OUTPUT SERVO is unipolar or bipolar. It is factory set to be bipolar so the auxiliary output can range from -10 V to +10 V. For some applications such as driving a PZT, limiting the voltage range to positive values is necessary. |
**Ramp Master / Slave (Jumper)** | **Ramp Master / Slave (Jumper)** |
d2/laser_servo.txt · Last modified: 2021/12/17 01:58 by 127.0.0.1