d2:laser_servo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
d2:laser_servo [2019/09/06 17:16] – [Right Side Panel] Michael Radunsky | d2:laser_servo [2019/09/06 17:35] – [Right Side Panel] Michael Radunsky | ||
---|---|---|---|
Line 273: | Line 273: | ||
This jumper is only accessible by removing the right side panel (see above) and sets whether the ramp input is in master or slave mode. It is factory set to be in MASTER MODE. In SLAVE MODE (jumper off) the RAMP signal is generated externally and input through the back panel RAMP I/O port. In MASTER MODE (jumper on) the ramp is generated internally and is sent out to the RAMP I/O port for driving other D2-125 Laser Servos configured in SLAVE MODE. | This jumper is only accessible by removing the right side panel (see above) and sets whether the ramp input is in master or slave mode. It is factory set to be in MASTER MODE. In SLAVE MODE (jumper off) the RAMP signal is generated externally and input through the back panel RAMP I/O port. In MASTER MODE (jumper on) the ramp is generated internally and is sent out to the RAMP I/O port for driving other D2-125 Laser Servos configured in SLAVE MODE. | ||
- | The slave ramp is multiplied by about -5x (at slave Ramp Amp maximum) | + | The amplitude of the slave ramp is about -5x of the master ramp input (at slave Ramp Amp maximum). The DC offset is applied |
====Lock Guard==== | ====Lock Guard==== |
d2/laser_servo.txt · Last modified: 2021/12/17 01:58 by 127.0.0.1