Differences

This shows you the differences between two versions of the page.

--- d2:laser_servo [2019/08/28 23:25] – [Monitor Section] Michael Radunsky
+++ d2:laser_servo [2019/09/06 17:16] – [Right Side Panel] Michael Radunsky
@@ Line 271: / Line 271: @@
 **Ramp Master / Slave (Jumper)**
 This jumper is only accessible by removing the right side panel (see above) and sets whether the ramp input is in master or slave mode. It is factory set to be in MASTER MODE. In SLAVE MODE (jumper off) the RAMP signal is generated externally and input through the back panel RAMP I/O port. In MASTER MODE (jumper on) the ramp is generated internally and is sent out to the RAMP I/O port for driving other D2-125 Laser Servos configured in SLAVE MODE.
+The slave ramp is multiplied by about -5x (at slave Ramp Amp maximum) from the master ramp input and then the DC offset is applied.
 ====Lock Guard====
@@ Line 378: / Line 380: @@
 <WRAP center round box 400px><imgcaption factory_settings|Factory settings for locking a D2-100>
-{{ {{ d2:d2-125:factory_settings_red.png?direct&400 |}} |}}</imgcaption></WRAP>
+{{ {{ d2:d2-125:factory_settings_red.png?direct&700 |}} |}}</imgcaption></WRAP>
 <WRAP center round box 60%><tabcaption factory_setting |D2-125 locking D2-100 or TOSA>