Product Manuals

User Tools

Site Tools

You are here: manuals » d2 » laser_servo
d2:laser_servo

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
d2:laser_servo [2019/07/15 23:00] – [Laser Lock Troubleshooting] Michael Radunskyd2:laser_servo [2019/08/28 23:26] – [Laser Lock Troubleshooting] Michael Radunsky
Line 98: Line 98:
 Located at the top of the front panel, the monitor section contains 6 BNC outputs for monitoring various signals used by the Laser Servo. The logic of the monitors is shown in <imgref image1>.  Open a {{d2:d2-125:d2-125_monitor_logic.pdf|pdf of this image }}. Located at the top of the front panel, the monitor section contains 6 BNC outputs for monitoring various signals used by the Laser Servo. The logic of the monitors is shown in <imgref image1>.  Open a {{d2:d2-125:d2-125_monitor_logic.pdf|pdf of this image }}.
  
-<WRAP center round box 420px><imgcaption image1|Monitor output logic>{{ d2:d2-125:d2-125_monitor_logic.jpeg?400|}}</imgcaption></WRAP>+<WRAP center round box 420px><imgcaption image1|Monitor output logic>{{ d2:d2-125:d2-125_monitor_logic.jpeg?600|}}</imgcaption></WRAP>
  
 **Error In** **Error In**
Line 378: Line 378:
  
 <WRAP center round box 400px><imgcaption factory_settings|Factory settings for locking a D2-100> <WRAP center round box 400px><imgcaption factory_settings|Factory settings for locking a D2-100>
-{{ {{ d2:d2-125:factory_settings_red.png?direct&400 |}} |}}</imgcaption></WRAP>+{{ {{ d2:d2-125:factory_settings_red.png?direct&700 |}} |}}</imgcaption></WRAP>
  
 <WRAP center round box 60%><tabcaption factory_setting |D2-125 locking D2-100 or TOSA> <WRAP center round box 60%><tabcaption factory_setting |D2-125 locking D2-100 or TOSA>
d2/laser_servo.txt · Last modified: 2021/12/17 01:58 by 127.0.0.1