Product Manuals

User Tools

Site Tools

You are here: manuals » d2 » laser_servo
d2:laser_servo

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
d2:laser_servo [2019/07/15 23:00] – [Laser Lock Troubleshooting] Michael Radunskyd2:laser_servo [2019/08/28 23:25] – [Monitor Section] Michael Radunsky
Line 98: Line 98:
 Located at the top of the front panel, the monitor section contains 6 BNC outputs for monitoring various signals used by the Laser Servo. The logic of the monitors is shown in <imgref image1>.  Open a {{d2:d2-125:d2-125_monitor_logic.pdf|pdf of this image }}. Located at the top of the front panel, the monitor section contains 6 BNC outputs for monitoring various signals used by the Laser Servo. The logic of the monitors is shown in <imgref image1>.  Open a {{d2:d2-125:d2-125_monitor_logic.pdf|pdf of this image }}.
  
-<WRAP center round box 420px><imgcaption image1|Monitor output logic>{{ d2:d2-125:d2-125_monitor_logic.jpeg?400|}}</imgcaption></WRAP>+<WRAP center round box 420px><imgcaption image1|Monitor output logic>{{ d2:d2-125:d2-125_monitor_logic.jpeg?600|}}</imgcaption></WRAP>
  
 **Error In** **Error In**
d2/laser_servo.txt · Last modified: 2021/12/17 01:58 by 127.0.0.1