Product Manuals

User Tools

Site Tools

You are here: manuals » d2 » laser_controller
d2:laser_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
d2:laser_controller [2023/01/06 22:35] – external edit 127.0.0.1d2:laser_controller [2023/02/14 01:53] – external edit 127.0.0.1
Line 275: Line 275:
 **Remote Interlock** **Remote Interlock**
  
-The remote interlock can be used to disable the laser diode output via an interlock control.  When this input is shorted the laser diode output is ON.  When the input is open the diode output is OFF.  If not used, leave a shorting cap over this BNC. Once the interlock has been tripped, the laser will stay off until it is manually reset with the front panel switch.+The remote interlock can be used to disable the laser diode output via an interlock control.  When this input is shorted the laser diode output is ON.  When the input is open the diode output is OFF.  If not used, leave a 50Ω BNC terminator over this BNC. Once the interlock has been tripped, the laser will stay off until it is manually reset with the front panel switch.
  
 **Setpoint In** **Setpoint In**
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano