d2:laser_controller
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
d2:laser_controller [2022/02/11 17:40] – external edit 127.0.0.1 | d2:laser_controller [2023/02/14 01:53] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 205: | Line 205: | ||
<WRAP center round important 60%> | <WRAP center round important 60%> | ||
- | Both temp control loops can be toggled with a board-level switch located under the PID tuning switches. If you are experiencing problems with either of your temp loops, please toggle this switch off and then on again, as it's possible for the switch to get bumped into an intermittent position where it looks on, but is off. The most common symptom of this issue is that the faulty temp loop's front panel LED will turn red, but this does not always happen. | + | Both temp control loops can be toggled with a board-level switch located under the PID tuning switches |
</ | </ | ||
Line 275: | Line 275: | ||
**Remote Interlock** | **Remote Interlock** | ||
- | The remote interlock can be used to disable the laser diode output via an interlock control. | + | The remote interlock can be used to disable the laser diode output via an interlock control. |
**Setpoint In** | **Setpoint In** |
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano