d2:laser_controller
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| d2:laser_controller [2022/02/11 17:40] – external edit 127.0.0.1 | d2:laser_controller [2023/01/06 22:35] – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 205: | Line 205: | ||
| <WRAP center round important 60%> | <WRAP center round important 60%> | ||
| - | Both temp control loops can be toggled with a board-level switch located under the PID tuning switches. If you are experiencing problems with either of your temp loops, please toggle this switch off and then on again, as it's possible for the switch to get bumped into an intermittent position where it looks on, but is off. The most common symptom of this issue is that the faulty temp loop's front panel LED will turn red, but this does not always happen. | + | Both temp control loops can be toggled with a board-level switch located under the PID tuning switches |
| </ | </ | ||
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano