Differences

This shows you the differences between two versions of the page.

--- d2:laser_controller [2021/06/10 21:20] – external edit 127.0.0.1
+++ d2:laser_controller [2021/12/17 00:00] – external edit 127.0.0.1
@@ Line 254: / Line 254: @@
 {{ :d2:d-sub_power_pinout.jpg?nolink&150 |}}
+While it is infrequent, the D2-005 power supply may occasionally radiate noise from the side of its chassis onto nearby electronics. This only occurs in some system configurations, and will appear as a signal at the frequency of your mains electricity (typically either 50 Hz or 60 Hz). This noise can easily be removed by moving the D2-005 at least 18 inches (45cm) away from other electronics, rotating it 90° such that the sides of the D2-005 face away, or by moving the entire power supply to a different shelf. To accommodate this, all D2-005's are shipped with a 5' DB9 cable as of January 1, 2022.
 **Laser Enable**
@@ Line 307: / Line 308: @@
   - Measure the resistance across GND5 and probe point GAIN2. Set this resistance to between 1.2 kΩ and 1.4 kΩ by adjusting trimpot PROPGAIN2.
-<WRAP center round box 570px><imgcaption factory_set_post6987|Factory settings of T2 (left) and T1 (right) poles for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)>[{{ :d2:d2-105:temp_loop_post_sn_6987_w_text.png?nolink&550 | filler text }}]</imgcaption></WRAP>
+<WRAP center round box 570px><imgcaption factory_set_post6987|Factory settings of T2 (left) and T1 (right) poles for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)>[{{ :d2:d2-105:Modern_Corners.jpg?nolink&550 | filler text }}]</imgcaption></WRAP>
 <WRAP center round box 60%><tabcaption factory_set2_post6987|Factory settings of T2 Proportional poles (first DIP switch in figure) and T2 Differential poles (second DIP switch in figure) for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)>