Product Manuals

User Tools

Site Tools

You are here: manuals » d2 » laser_controller
d2:laser_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
d2:laser_controller [2021/06/10 21:20] – external edit 127.0.0.1d2:laser_controller [2021/08/26 14:26] – external edit 127.0.0.1
Line 307: Line 307:
   - Measure the resistance across GND5 and probe point GAIN2. Set this resistance to between 1.2 kΩ and 1.4 kΩ by adjusting trimpot PROPGAIN2.   - Measure the resistance across GND5 and probe point GAIN2. Set this resistance to between 1.2 kΩ and 1.4 kΩ by adjusting trimpot PROPGAIN2.
  
-<WRAP center round box 570px><imgcaption factory_set_post6987|Factory settings of T2 (left) and T1 (right) poles for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)>[{{ :d2:d2-105:temp_loop_post_sn_6987_w_text.png?nolink&550 | filler text }}]</imgcaption></WRAP>+<WRAP center round box 570px><imgcaption factory_set_post6987|Factory settings of T2 (left) and T1 (right) poles for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)>[{{ :d2:d2-105:Modern_Corners.jpg?nolink&550 | filler text }}]</imgcaption></WRAP>
  
 <WRAP center round box 60%><tabcaption factory_set2_post6987|Factory settings of T2 Proportional poles (first DIP switch in figure) and T2 Differential poles (second DIP switch in figure) for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)> <WRAP center round box 60%><tabcaption factory_set2_post6987|Factory settings of T2 Proportional poles (first DIP switch in figure) and T2 Differential poles (second DIP switch in figure) for units with S/N 2675 or higher (PCBs with S/N 6987 and higher)>
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano