d2:laser_controller
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| d2:laser_controller [2020/10/29 21:53] – Michael Radunsky | d2:laser_controller [2020/12/01 19:30] – Michael Radunsky | ||
|---|---|---|---|
| Line 155: | Line 155: | ||
| When the switch is in the Off/Reset position, the laser diode is turned off and the laser is shorted to ground. When flipped into the On position, the Laser ON (LED indicator) will turn on and 5s later, the laser will turn on. If the laser diode is turned off from the laser enable or remote interlock, this switch must to placed into the Off/Reset position and then into the ON position to turn the laser back on. | When the switch is in the Off/Reset position, the laser diode is turned off and the laser is shorted to ground. When flipped into the On position, the Laser ON (LED indicator) will turn on and 5s later, the laser will turn on. If the laser diode is turned off from the laser enable or remote interlock, this switch must to placed into the Off/Reset position and then into the ON position to turn the laser back on. | ||
| - | Neither the laser nor the Laser ON (LED indicator) will not turn on if any of the following conditions are true: | + | Neither the laser nor the Laser ON (LED indicator) will turn on if any of the following conditions are true: |
| - The remote interlock is not engaged | - The remote interlock is not engaged | ||
| - The key interlock is not engaged | - The key interlock is not engaged | ||
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano