Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
d2:laser_controller [2020/05/29 21:47] – Michael Radunsky | d2:laser_controller [2020/09/11 23:19] – Michael Radunsky |
---|
**Laser Temp Output (8-pin connector)** | **Laser Temp Output (8-pin connector)** |
| |
An 8-pin Hirose connector (see <tabref TECconnectortable> for identity of connectors) carries the signals for the temperature control of the Laser module. The wiring diagrams are shown in the table below, where 1 (2) refer to stage 1 (2) temperature control, which stabilizes the Laser Housing (Laser Diode). Rth and Rth_Rtn are the two ends of a 10 kΩ [[http://www.analogtechnologies.com/ath10kr8.html|Analog Technologies ATH10KR8 Thermistor]]. | An 8-pin Hirose connector (see <tabref TECconnectortable> for identity of connectors) carries the signals for the temperature control of the Laser module. The wiring diagrams are shown in <tabref TEC_connector_pinout> below, where 1 (2) refer to stage 1 (2) temperature control, which stabilizes the Laser Housing (Laser Diode). Rth and Rth_Rtn are the two ends of a 10 kΩ [[http://www.analogtechnologies.com/ath10kr8.html|Analog Technologies ATH10KR8 Thermistor]]. |
| |
<WRAP round center box 230px><tabcaption TEC_connector_pinout| TEC connector pin out> | <WRAP round center box 230px><tabcaption TEC_connector_pinout| TEC connector pin out> |