User Tools

Site Tools


d2:laser_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
d2:laser_controller [2019/03/20 01:01] Michael Radunskyd2:laser_controller [2019/03/25 20:59] Michael Radunsky
Line 272: Line 272:
  
 When disconnected, the SETPOINT ENABLE is at 5 V. When disconnected, the SETPOINT ENABLE is at 5 V.
 +
 +The Servo Input on the front panel continues to function when the SETPOINT ENABLE is pulled low.
  
 =====Turning on the Laser Diode===== =====Turning on the Laser Diode=====
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano