User Tools

Site Tools


d2:d2_250_heterodyne_module

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
d2:d2_250_heterodyne_module [2016/05/12 15:07]
Michael Radunsky [Alignment Procedure]
d2:d2_250_heterodyne_module [2016/05/12 15:08] (current)
Michael Radunsky [Alignment Procedure]
Line 86: Line 86:
 Block laser #1, and rotate the "​INPUT2"​ waveplate to reduce the observed power below 0.50mW. Block laser #2, and rotate the "​INPUT1"​ waveplate to reduce the observed power below 0.50mW. To protect the D2-160 Beat Note module, the combined power should not exceed 1mW. The SC fiber end can now be connected to the D2-160 or other beat note detector. Block laser #1, and rotate the "​INPUT2"​ waveplate to reduce the observed power below 0.50mW. Block laser #2, and rotate the "​INPUT1"​ waveplate to reduce the observed power below 0.50mW. To protect the D2-160 Beat Note module, the combined power should not exceed 1mW. The SC fiber end can now be connected to the D2-160 or other beat note detector.
  
-<​imgcaption 250-top|D2-250 Heterodyne Module>​{{ :​d2:​d2_250:​d2-215-top-down.png?​300 }}</​imgcaption>​+
d2/d2_250_heterodyne_module.txt · Last modified: 2016/05/12 15:08 by Michael Radunsky