Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision |
d2:d2_250_heterodyne_module [2016/05/12 22:07] – [Alignment Procedure] Michael Radunsky | d2:d2_250_heterodyne_module [2021/08/26 15:26] (current) – external edit 127.0.0.1 |
---|
Block laser #1, and rotate the "INPUT2" waveplate to reduce the observed power below 0.50mW. Block laser #2, and rotate the "INPUT1" waveplate to reduce the observed power below 0.50mW. To protect the D2-160 Beat Note module, the combined power should not exceed 1mW. The SC fiber end can now be connected to the D2-160 or other beat note detector. | Block laser #1, and rotate the "INPUT2" waveplate to reduce the observed power below 0.50mW. Block laser #2, and rotate the "INPUT1" waveplate to reduce the observed power below 0.50mW. To protect the D2-160 Beat Note module, the combined power should not exceed 1mW. The SC fiber end can now be connected to the D2-160 or other beat note detector. |
| |
<imgcaption 250-top|D2-250 Heterodyne Module>{{ :d2:d2_250:d2-215-top-down.png?300 }}</imgcaption> | |