User Tools

Site Tools


d2:beat_note_detector

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
d2:beat_note_detector [2016/03/25 14:20]
Michael Radunsky [Specifications]
d2:beat_note_detector [2017/10/11 17:29] (current)
Michael Radunsky [Operating Instructions]
Line 51: Line 51:
 ^Dimensions |  1.38 x 1.25 x ~1.7  | inches | ^Dimensions |  1.38 x 1.25 x ~1.7  | inches |
 </​WRAP>​ </​WRAP>​
-__=====Operating Instructions=====+__ 
 +=====Operating Instructions=====
  
 <WRAP center round important 60%> <WRAP center round important 60%>
Line 59: Line 60:
  
 ==Powering the D2-160== ==Powering the D2-160==
 +<WRAP center round important 60%>
 +Never connect this device to a power supply that is switched on and supplying power. ​ Always turn off the power supply, make connections to this device, and then re-energize the power supply. ​
 +</​WRAP>​
 The D2-160 requires +5 VDC and ground to operate. ​ The power input is via a female 6-pin Hirose connector [[http://​www.digikey.com/​product-search/​en?​KeyWords=HR10A-7TR-6SA(73)&​WT.z_header=search_go|HR10A-7TR-6SA(73)]]. If you are making your own power cable, pin 4 is +5 V and pin 6 is ground. ​ Use a 6-pin male Hirose connector [[http://​www.digikey.com/​product-search/​en?​KeyWords=HR10A-7TP-6P(73)&​WT.z_header=search_go|HR10A-7TP-6P(73)]]. ​ Depending on your order configuration,​ you should have received a power cable with this connector on one end and either the same on the other (typically for using with ICE products) or a DB-9 connector (with D2-products). The D2-160 requires +5 VDC and ground to operate. ​ The power input is via a female 6-pin Hirose connector [[http://​www.digikey.com/​product-search/​en?​KeyWords=HR10A-7TR-6SA(73)&​WT.z_header=search_go|HR10A-7TR-6SA(73)]]. If you are making your own power cable, pin 4 is +5 V and pin 6 is ground. ​ Use a 6-pin male Hirose connector [[http://​www.digikey.com/​product-search/​en?​KeyWords=HR10A-7TP-6P(73)&​WT.z_header=search_go|HR10A-7TP-6P(73)]]. ​ Depending on your order configuration,​ you should have received a power cable with this connector on one end and either the same on the other (typically for using with ICE products) or a DB-9 connector (with D2-products).
  
d2/beat_note_detector.txt · Last modified: 2017/10/11 17:29 by Michael Radunsky