Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| d2:beat_note_detector [2016/03/25 21:07] – [Specifications] Michael Radunsky | d2:beat_note_detector [2021/08/26 15:26] (current) – external edit 127.0.0.1 |
|---|
| ^Dimensions | 1.38 x 1.25 x ~1.7 | inches | | ^Dimensions | 1.38 x 1.25 x ~1.7 | inches | |
| </WRAP> | </WRAP> |
| _ | __ |
| _=====Operating Instructions===== | =====Operating Instructions===== |
| |
| <WRAP center round important 60%> | <WRAP center round important 60%> |
| |
| ==Powering the D2-160== | ==Powering the D2-160== |
| | <WRAP center round important 60%> |
| | Never connect this device to a power supply that is switched on and supplying power. Always turn off the power supply, make connections to this device, and then re-energize the power supply. |
| | </WRAP> |
| The D2-160 requires +5 VDC and ground to operate. The power input is via a female 6-pin Hirose connector [[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TR-6SA(73)&WT.z_header=search_go|HR10A-7TR-6SA(73)]]. If you are making your own power cable, pin 4 is +5 V and pin 6 is ground. Use a 6-pin male Hirose connector [[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TP-6P(73)&WT.z_header=search_go|HR10A-7TP-6P(73)]]. Depending on your order configuration, you should have received a power cable with this connector on one end and either the same on the other (typically for using with ICE products) or a DB-9 connector (with D2-products). | The D2-160 requires +5 VDC and ground to operate. The power input is via a female 6-pin Hirose connector [[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TR-6SA(73)&WT.z_header=search_go|HR10A-7TR-6SA(73)]]. If you are making your own power cable, pin 4 is +5 V and pin 6 is ground. Use a 6-pin male Hirose connector [[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TP-6P(73)&WT.z_header=search_go|HR10A-7TP-6P(73)]]. Depending on your order configuration, you should have received a power cable with this connector on one end and either the same on the other (typically for using with ICE products) or a DB-9 connector (with D2-products). |
| |
